transition, and not set in case of HW_AUTO transition.

For OMAP4 devices, all CLKDMs support HW_AUTO and therefore we can place the
CLKDMs in the HW_AUTO state instead of the SW_SLEEP mode. Hence, we do not
need to use the SW_SLEEP mode. With regard to NO_SLEEP and SW_WKUP it is
preferred to use SW_WKUP mode if the CLKDM supports it and so use this mode
instead of NO_SLEEP where possible.

For a software perspective the above 4 modes are represented by the following
flags to indicate what modes are supported by each of the CLKDMs.

CLKDM_CAN_DISABLE_AUTO	--> NO_SLEEP
CLKDM_CAN_ENABLE_AUTO	--> HW_AUTO
CLKDM_CAN_FORCE_SLEEP	--> SW_SLEEP
CLKDM_CAN_FORCE_WAKEUP	--> SW_WKUP

By eliminating the SW_SLEEP mode the the mapping of the flags for OMAP4 devices
can becomes ...

CLKDM_CAN_DISABLE_AUTO	--> NO_SLEEP
CLKDM_CAN_ENABLE_AUTO	--> HW_AUTO
CLKDM_CAN_FORCE_SLEEP	--> HW_AUTO
CLKDM_CAN_FORCE_WAKEUP	--> SW_WKUP

Cc: Ming Lei <ming.lei@canonical.com>
Cc: Will Deacon <will.deacon@arm.com>
Cc: Benoit Cousson <b-cousson@ti.com>
Cc: Paul Walmsley <paul@pwsan.com>
Cc: Kevin Hilman <khilman@ti.com>
Reviewed-by: Benoit Cousson <b-cousson@ti.com>
Reviewed-by: Santosh Shilimkar <santosh.shilimkar@ti.com>
Signed-off-by: Jon Hunter <jon-hunter@ti.com>
Signed-off-by: Paul Walmsley <paul@pwsan.com>
 Ë1 œ>x