223.701883] xhci_hcd 0000:03:00.0: @ffff880137b25048 (virt) @ffffc048 (dma) 0xffffe8e0 - deq [ 223.701885] xhci_hcd 0000:03:00.0: @ffff880137b25050 (virt) @ffffc050 (dma) 0x000000 - tx_info [ 223.701887] xhci_hcd 0000:03:00.0: @ffff880137b25054 (virt) @ffffc054 (dma) 0x000000 - rsvd[0] [ 223.701889] xhci_hcd 0000:03:00.0: @ffff880137b25058 (virt) @ffffc058 (dma) 0x000000 - rsvd[1] [ 223.701892] xhci_hcd 0000:03:00.0: @ffff880137b2505c (virt) @ffffc05c (dma) 0x000000 - rsvd[2] ... [ 223.701927] xhci_hcd 0000:03:00.0: // Ding dong! [ 223.701992] xhci_hcd 0000:03:00.0: Setup ERROR: address device command for slot 1. The xHCI spec says that both flags must be set to one for the Address Device command. When the device is first enumerated, xhci_setup_addressable_virt_dev() does set those flags. However, when the device is addressed after it has been reset in the configured state, xhci_setup_addressable_virt_dev() is not called, and xhci_copy_ep0_dequeue_into_input_ctx() is called instead. That function relies on the flags being set up by previous commands, which apparently isn't a good assumption. Move the setting of the flags into the common parent function. This should be queued for stable kernels as old as 2.6.35, since that was the first introduction of xhci_copy_ep0_dequeue_into_input_ctx. Signed-off-by: Sarah Sharp Tested-by: Matt Cc: stable@vger.kernel.org H6!