stack after DNAT
depending on the source address type. Local client sets output
route and the remote client sets input route. It looks like
IPv6 does not need such rerouting because the replies use
addresses from initial incoming header, not from skb route.

- All transmitters now have strict checks for the destination
address type: redirect from non-local address to local real
server requires NAT method, local address can not be used as
source address when talking to remote real server.

- Now LOCALNODE is not set explicitly as forwarding
method in real server to allow the connections to provide
correct forwarding method to the backup server. Not sure if
this breaks tools that expect to see 'Local' real server type.
If needed, this can be supported with new flag IP_VS_DEST_F_LOCAL.
Now it should be possible connections in backup that lost
their fwmark information during sync to be forwarded properly
to their daddr, even if it is local address in the backup server.
By this way backup could be used as real server for DR or TUN,
for NAT there are some restrictions because tuple collisions
in conntracks can create problems for the traffic.

- Call ip_vs_dst_reset when destination is updated in case
some real server IP type is changed between local and remote.

[ horms@verge.net.au: removed trailing whitespace ]
Signed-off-by: Julian Anastasov <ja@ssi.bg>
Signed-off-by: Simon Horman <horms@verge.net.au>
S6