#!/bin/sh

set -e

case "$1" in
        configure)
                invoke-rc.d --quiet acpid restart > /dev/null || true
                ;;
        *)
                ;;
esac

# Automatically added by dh_installinit/13.15.3
if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then
	if [ -x "/etc/init.d/acpi-support" ]; then
		update-rc.d acpi-support defaults >/dev/null || exit 1
	fi
fi
# End automatically added section
# Automatically added by dh_installsystemd/13.15.3
if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then
	# The following line should be removed in trixie or trixie+1
	deb-systemd-helper unmask 'acpi-support.service' >/dev/null || true

	# was-enabled defaults to true, so new installations run enable.
	if deb-systemd-helper --quiet was-enabled 'acpi-support.service'; then
		# Enables the unit on first installation, creates new
		# symlinks on upgrades if the unit file has changed.
		deb-systemd-helper enable 'acpi-support.service' >/dev/null || true
	else
		# Update the statefile to add new symlinks (if any), which need to be
		# cleaned up on purge. Also remove old symlinks.
		deb-systemd-helper update-state 'acpi-support.service' >/dev/null || true
	fi
fi
# End automatically added section
# Automatically added by dh_installsystemd/13.15.3
if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then
	if [ -d /run/systemd/system ]; then
		systemctl --system daemon-reload >/dev/null || true
		if [ -n "$2" ]; then
			_dh_action=restart
		else
			_dh_action=start
		fi
		deb-systemd-invoke $_dh_action 'acpi-support.service' >/dev/null || true
	fi
fi
# End automatically added section